UCP Commands Introduction
4-183
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4.8.7 UCP Commands
To configure a UFO VLAN on an interface, the previously described ADD VLAN INTERFACE and SET VLAN
INTERFACE commands are used, which include UCP as a FOWARDING parameter value.
EPSR, with UCP EPSR Master Node is any node in the ring
Primary Upstream port can be on any node in the ring, independent of the Mas-
ter Node
Secondary Upstream port can be on any node in the ring, independent of the
Master Node
EPSR and RSTP, with UCP Topology must be loop-free as described in EPSR and RSTP sections
Primary Upstream port can be located anywhere.
Secondary Upstream port can be located anywhere.
TABLE 4-25 Configurations with and without UCP and Associated Rules
Configuration Rules
To Next Page
Loading...
