Introduction Configuring LLDP
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
7-88
SETDEFAULTS LLDP
Syntax
SETDEFAULTS LLDP [ TXINTERVAL ] [ TXHOLD ] [ TXDELAY ] [ REINITDE-
LAY ] [ NOTIFYINTERVAL ]
Description Sets the defaults for the global LLDP values. This command would be used to change
back to the default values that had been changed by the SET LLDP command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SETDEFAULTS LLDP
Option Description Default Value
LLDP value Refer to Tab le 7 -9 .
To Next Page
Loading...
