Introduction Configuring the Management Interfaces
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-58
Caution: The inband interface can be accessed from any port. Therefore, avoid provisioning subscriber ports
on the inband VLAN
TABLE 1-7 Configure the MGMT Interface
Step Action or State Details
1
Enable the telnet server
ENABLE TELNET SERVER
Required before telnet interfaces can be used
2
SET IP INTERFACE=MGMT
IPADDRESS=10.52.66.220
SUBNETMASK=255.255.255.0
Sets the IP address and subnet mask for the manage-
ment interface.
3
SET SYSTEM GATEWAY 10.51.66.1 Sets the system gateway.
4
Set system DNS (if not already set)
SET SYSTEM DNS 10.4.5.7,10.52.7.50
This step is optional.
5
Set system domain name (if not already set)
SET SYSTEM DOMAINNAME ALLIED-SYSTEM-1
This step is optional.
The domain name is a string of 1 to 63 characters in
length.
6
ENABLE IP INTERFACE=MGMT Enables the interface so management-related data
can be transmitted and received.
7
SHOW IP INTERFACE=MGMT
Interface.......................... ETH:0 (MGMT)
IP State........................... Enabled
Provisioning
IP Address...................... 10.52.66.220
Subnet Mask..................... 255.255.255.0
Gateway......................... 10.52.66.1
DNS............................. <none>
Domain Name..................... <none>
Card............................ ACTCFC
MGMT............................ Yes
This shows a dedicated MGMT interface has been
configured.
Note: The SBx3112 only supports a single
default gateway, DNS server, and
Domain Name, and so these
parameters do not appear on the SET
IP INTERFACE and ADD IP
INTERFACE commands.
TABLE 1-8 Configure the Inband Interface
Step Action or State Details
1
Create the VLAN to be used for the inband interface
CREATE VLAN INBAND VID 420
2
Add the VLAN to the Network interface
ADD VLAN INBAND INTERFACE 1.0 FRAME TAGGED
3
Add the IP interface to the VLAN
ADD IP INTERFACE VLAN:420.0 IPADDRESS 10.51.66.101 SUBNET-
MASK 255.255.255.0 IFNAME INBAND
To Next Page
Loading...
