Preparing Cameras without
Sensor Cover Glass
Page 12 of 18
You have access to the sensor now.
9. Continue with 9.3. Removing the taped cover glass on page 12.
9.3. Removing the taped cover glass
Figure 18: sensor unit and sensor
Ease handling
• Use a magnifying glass for better view.
• Read the instructions thoroughly and keep tools at hand for camera
preparation.
Use of the term “camera” in this section
In this section, the term "camera" includes sensor units of Prosilica GT cameras.
Required tools
Before you can remove the TCG, please obtain the required tools shown below.
Required tools Tools short names Purpose
Base magnifier or microscope Magnifying glass For better view
Wooden spatula Spatula To keep the cover glass in position until removed
Precision screwdriver Screwdriver To lift up the adhesive tapes
Pinch nose pliers Pliers To pull off the adhesive tapes
Circular protection foil
(optional)
Circular protection foil To protect the sensor during camera storage
before final hardware installation
Table 3: Required tools to remove a TCG
Sensor
To Next Page
Loading...
