English - 3 / 12 6-1622780 - rev.4 - 02/08/2021
WIRING DIAGRAM
POWER SUPPLY
Black / - Ground
} VCC
Red / + +Vcc
RELAY 1
Rose / COM1 Common Relay 1
} NO1
White / NO1 Contact Normally Open Relay 1
Rose / COM1 Common Relay 1
} NC1
Clear Blue / NC1 Contact Normally Close Relay 1
RELAY 2
Purple / COM2 Common Relay 2
} NO2
Blue / NO2 Contact Normally Open Relay 2
Purple / COM2 Common Relay 2
} NC2
Grey / NC2 Contact Normally Close Relay 2
EXIT BUTTON
Orange / BP1 Button relay 1
} BP1
Green / GND Ground
Yellow / BP2 Button relay 2
} BP2
Green / GND Ground
DOOR CONTACT
Brown / BP1 Button relay 1
} CP
Green / GND Ground
PROGRAMMATION
KEY:
O
= LED Orange;
G
= LED Green;
R
= LED Red; = LED flashing
= Small sound; = Long sound
Enter programming mode
Enter the MASTER CODE twice.
(default MASTER CODE = "1234")
O
Exit programming mode
Press once.
G
Note: Exit programming mode is automatic after 60 seconds idle.
Change code digits number
Attention: This operation delete every registered codes.
Enter programming mode .
Select the menu by pressing
O
Enter "X" the digits number (from 2 to 6).
Defaults Master Codes:
X=2 –> "12"; X=3 –> "123"; X=4 –> "1234"; X=5 –> "12345"; X=6 –> "123456"
O
Exit the programming mode .
To Next Page
Loading...