16 - English - Translated from the original language Manual 6-1624970M - rev. 1 - 11/01/2023
3.2 - INSTALLATION OF THE GEAR MOTOR
Remove the screws, remove the outer cover and unlock the motor transmission.
Place the gear motor, aligning it, above the fixing plate.
The threaded part of the hooks must pass through the slots of the gear motor body.
NOTE
• The electrical cables must pass through the appropriate hole at the bottom of the motor body.
3.3 - FIXING OF THE RACK
Place a piece of rack over the pinion and fix it to the gate, taking care that the rack is level and has a constant distance from the
pinion of 1-2 mm.
Attach the rack to the gate in its entire length.
To assemble the rack modules, use a scrap piece by placing it under the joint point and locking it with two clamps.
NOTE
• The weight of the gate should not burden the automation.
• The pinion must be centered on the rack width.
1mm...2mm
To Next Page
Loading...
