30 - English - Translated from the original language Manual 6-1624970M - rev. 1 - 11/01/2023
5.5 - LEARNING OF A REMOTE CONTROL
The learning of a transmitter can be activated via the UP button of the control unit or via the hidden button of a transmitter already
stored.
The control unit can store up to 1000 remote controls (with memory card) and each of them can associate up to 4 functions, no
more than one function per key available. During the learning procedure a single function is stored in a transmitter button. To assign
all 4 available functions you will need to repeat the procedure 4 times.
Functions are assigned in the following order:
• 1
st
stored key: STEP-BY-STEP function.
• 2
nd
stored key: PARTIAL OPENING function.
• 3
rd
stored key: OPEN function.
• 4
th
stored key: CLOSE function.
STANDARD LEARNING OF A TRANSMITTER
NOTE
• To store a new remote control or a new function on the same remote control, repeat the procedure from
step 2.
• After 10 seconds of inactivity the control panel leaves the learning mode and the display shows " tout ".
1.
Make sure you are out of the programming menus.
To exit, briefly press the MENU key until you see the status of the
control panel.
SS
2.
While the automation is stopped, press and release the UP button.
The word " rad " appear on the display.
The flashing light comes on.
SS
3. Within 10 seconds, press the transmitter button to learn.
4.a
If the remote control is the first time it is learned, the word " don "
appears in the display. The STEP-BY-STEP function is associated with
the pressed button.
The flashing light flashes 2 times.
4.b
If the remote control was already stored in the control unit, the words
" fnd " appear in the display. The pressed key is associated with the
function PARTIAL OPENING, OPEN or CLOSE depending on how many
times this procedure has been repeated.
The flashing light flashes 1.
5.
After 2 seconds the display shows the memory position where the
remote control was stored (for example " 235 ").
To Next Page
Loading...
