1 ENTER
7 ENTER
Monday through Sunday (all week) is set for the day range and the
display blinks “12:00”.
1200 ENTER 12:00 is set for the beginning time and the display blinks “12:00
AM” and waits for the AM LED to be set (or cleared).
ENTER 12:00 AM is set for the beginning time and the display blinks
“12:00” and waits for the ending time.
500 ENTER 5:00 is set for the ending time and the display blinks “5:00 AM”
and waits for the AM LED to be set (or cleared).
ENTER 5:00 AM is set for the ending time and the display blinks “C” and
waits for the child numbers to be entered.
14 ENTER Sets child 1 and child 4 as being affected by this interval. The
display blinks “Lo” and waits for one of the digits 1, 2, or 3
ENTER The Lock Out Interval function ends
To view the lockout intervals use the LOOK key and enter the number of one of the children that is affected by a
lockout interval.
As an example if you wanted to view child one’s allowance (while in Parent/Programming) mode, time
remaining, access code, and lockout intervals you would press the following keys (assume that the allowance for
child one is 2 hours and 15 minutes, the time remaining in his account is 1 hour and 45 minutes, and his access
code is 9999). Also assume that three lockout intervals as set up above are in effect.
Key(s) Pressed Action Taken
LOOK The display blinks “L”
If you press ENTER or CLEAR instead of one of the numbers from
1 to 4 then the look function aborts and you are back in PARENT
mode.
To Next Page
Loading...
Need help?
General