5. Pond installation - place your CUV unit at least 2 metres away from pond.
This is to ensure the UV unit cannot fall into the pond. Connect pipework from
feeder pump (not included) to inlet hosetail and secure using clip/clamp.
Connect pipework to hosetail outlet to feed into filtration system (not included)
or return water to pond to ensure this is water tight.
6. Aquarium installation - place your CUV unit securely on a flat surface.
Connect outlet pipework from aquarium pump or external filter to CUV inlet
hosetail.
Connect pipework to hosetail outlet to return water to aquarium. Secure all
pipework using hose clip/clamp to ensure this is water tight..
5. Connect your CUV to the mains - connect the unit to the mains using a
residual current device (RCD) for additional safety.
6. Switch on your unit at the mains - turn on the operation by switching on the
unit at the mains.
To Next Page
Loading...
