Need help?Do you have a question about the Almost Heaven Saunas Bridgeport and is the answer not in the manual?
General| Brand | Almost Heaven Saunas |
|---|---|
| Model | Bridgeport |
| Category | Plumbing Product |
| Language | English |
All electrical wiring must be performed by a qualified licensed electrician using copper wire with 90°C insulation.
Your sauna can be assembled on any surface that is firm and flat, such as concrete or tile.
Check your boxes against the shipping list and gather basic tools for assembly.
Connect the 4 floor risers and attach the wall support rails to form the base.
Position and connect wall sections A through J, including window and door panels.
Build the roof support by assembling rails and attach the roof sections.
Position and attach the lower long bench, lower side bench, and upper long bench.
Measure, drill, mount the power supply, and attach the back rest with LED lighting.
Install the door knob by inserting the thread through the door hole.
Mount the heater on Wall Section F and follow electrical codes for wiring.
Assemble the four fence kit pieces and position around the heater.
Clean the sauna, rinse stones, and perform the initial heating cycle.
Steps for taking a sauna bath, including temperature, steam, and cooling.
To Next Page
