2
S
PECIFICATIONS
:
Condition
Key
Pressed alone Pressed while
F is pressed
Press and hold and
turn the power on
F (DJ-S41T: If released quickly,
freq. Change by digits)
reset
MONI unmutes squelch keylock/unlock beep on/off
PTT transmits
V/M VFO
Memory Memory Write Channel Indication
Mode
UP freq./mem up (scans if pressed
a while) (If pressed with PTT,
emits alert tone.)
channel step stand-by beep ON
DOWN freq./mem down (scans if
pressed awhile) (If pressed
with PTT, emits alert tone.
tone freq. change stand-by beep OFF
CALL call channel alarm on/off alert/1750Hz
SCAN scan start offset programming
LAMP lamp on/off Auto Power Off change lamp mode
2O
THER
F
UNCTIONS
Stand-By Beep:
A short beep is emitted on you transmitting signal upon each release of the PTT
key, to let the other party "go ahead" and talk, To toggle on this function, press and hold the UP key
and turn on the power. To toggle off, do the same with the DOWN key.
Reverse:
To monitor the uplink frequency of the repeater (then an offset has been programmed),
press RPT, than F + SHIFT, then press and hold the MONITOR key. Releasing the MONITOR key
will cancel the reverse reception and pressing PTT will bring bact to the original state.
Key Stroke Beep Sound:
The beep heard with each stroke of keys can be toggled on/off, by
pressing and holding the MONITOR key and turning the power on.
Channel Display Mode:
Only the memory channel number (and not the frequency) is displayed.
If your operations is limited on your "usual" channels only, this setting maybe useful. This mode can
be entered/exited by press/holding the V/M key and turning the power on.
R
ESETTING
:
PRESS AND HOLD THE
F-
KEY AND TURN ON THE POWER
.
To Previous Page
Loading...