GB
9
Rotary switch set for hammer mode. Wait for
the drill to stop before changing!
Please note: This switch should be
in ‘drill’ position when drilling holes in tiles.
Rotary switch set for drilling mode. Wait for the
drill to stop before changing!
On/Off switch:
To switch on: Press switch A
Continuous operation: Lock switch A with
locking button B
To switch off: Press switch A briefly
The speed is varied by applying more or less
pressure on switch A. You can preselect the
speed by turning the knurled screw in switch A.
A
B
To Next Page
Loading...
