2
Installing the receiver
The receiver must be installed into the boiler control panel, refer to the boiler installation
manual for guidance.
Installing the programmable room thermostat
The Alpha Easy-Stat is a programmable room thermostat and must be installed in the correct
position, approximately 1.5 meters from the ground and must not be fitted in any of the
following positions;
1. In direct sunlight
2. Near a heat source i.e. radiator, fire etc.
3. In an area where it can be influenced by a draught
4. Near or behind curtains or furniture
A typical location for the unit would be in a hallway or open plan living area exposed to the
room temperature being controlled.
The left side of the controller must be a minimum of 100mm from a corner or obstructions to
allow the replacement of the two AA type batteries. Please observe the correct polarity on the
batteries when removing or replacing.
Separate the timer by pressing the top, bottom and side of the rear section and gently pull
apart being careful not to pull the wires within the unit, unplug the wires from the PCB.
Receiver
Transmit button
To Next Page
