Alpha VS 100 - Pitch control

***
NQTE
3: It's
a good
idea to keep
track
of
the
messages
and
corresponding
line numbers
that you
use.
It
will make
it
easier
to
add
them
to your
programs later.
&
NOTE
4: NEWDOS+
2.1
users:
you will
have to
disable
the
automatic
conversion
of lower
case to
upper
case
if
you
want
to use
pitch
2.
IMPORTANT
:
There
are
some
limitations
involved
in saving
messages
with various
pitches.
Refer to
the
"Pitch
Control" section
of this
manual
if you want
to use
pitches
other
than the
default
pitch
.
—
1
-
Recall
from
disk
(disk
version
only
)
. This
lets
you
get
one
of the
messages
that you saved
to disk
so that
you can change
it
.
You
are
asked
for the
file name.
Type
it in
and press
<enter>.
The file
must
be an
ASCII
(text)
file for
VSEDIT
to work.
You
will then
be asked
for the
line number.
Type
the line
corresponding
to the
message
you want to
edit
and
press
<enter>
.
NOTE
:
When
you save
the
changed message,
note that VSEDIT
will
add
the new
line to
the
end of
the
existing file.
It
will not
overwrite
the
previous
line with
that number
until
it
is
LOADed
into
BASIC
(NEWDOS/80
version
2.0 will
not
work
if the
lines aren't
in order).
Page
24