INSTALLATION continued
Once you have tested your system and have conrmed that it is
operating properly, turn off your system and prepare for the nal mounting
of the speakers.
1. Position the speaker into the mounting hole and reconrm the
correct mounting location and hole placement. Screw clips are
provided to insure a snug t. Place screw clips over the metal surface
and line up the hole with the hole you have previously drilled. Place the
speaker into the hole, align the mounting holes and proceed to insert
the screws. Be sure to tighten the screws evenly as to not warp the
speaker frame.
2. Turn your system back on and conrm the speaker’s operation, rst at
low volume and then you may increase the volume as you desire.
3. Carefully inspect the speakers surrounding and make sure the area
does not obstruct the mounting of the grill.
8
To Next Page
Loading...
