Alpine 7915M - Page 15

Manual Tuning
1. Press the TUNE switch ® until the SEEK @ and A. MEMO @8 indicators disappear in
the display.
2. To select the tuning band, press the BAND button @. The Band indicator () shows
your selection.
3. To tune to higher frequencies, press the M.S. - CD switch on the right (UP) ©. To tune
to lower frequencies, press this same switch on the left (DowN) ®.
Auto SEEK Tuning
1. Press the TUNE switch ® until the SEEK indicator @ appears in the display.
2. Select the tuning band with the BAND button ©.
3. Press the UP © or DowN ©® switch. The unit automatically tunes to the next higher or
lower frequency and locks on that station.
Manual Memory Preset
Follow the instructions below to enter stations into preset memory:
1. Select the tuning band (FM1, FM2, MW, LW) with the BAND button @®.
2. Tune in your desired station using Manual or Auto Seek tuning.
3. Press the Preset button number 1 @ for more than two seconds. The matrix display @
will begin to blink. The tuning band (FM1, FM2) can be changed by pressing the BAND
button @ if you wish to change bands. Press that preset button again while the display
is blinking (within 5 seconds).
4. The frequency you selected will be placed into Preset Memory number 1 and will
appear in the display.
NOTE:
lf a preset memory has already been set in the same address, it will be cleared and
the new station will be memorized.
5. Follow steps 2 — 3 for the remaining presets (2 — 6). This procedure should be
followed for FM1, FM2, MW and LW.
NOTE:
While setting the memory presets you can switch back and forth between FM1 and
FM2. However, while in this mode you cannot switch back and forth from MW/LW to FM.
Auto Memory Preset
1. Press the TUNE switch @® to light up the A. MEMO indicator @.
2. Select the desired tuning band (FM1, FM2, MW or LW) with the BAND button @.
NOTE:
The Auto Memory Preset procedure is allowed in the D.A.P. Mode.
3. Press the UP © or DN ® switch. The tuner will automatically seek the six strongest
stations in the selected band and memorize them in order of their signal strength.
These stations are automatically placed in the preset memory with the strongest
station in Preset No. 1 and the 6th strongest station in Preset No. 6. When seeking
stations, the tuner first seeks in the local tuning mode. If less than 6 stations are
memorized, the tuner seeks again in the distance (DX) mode.
4. After finishing the Auto Memory Preset, the tuner goes to the station placed in Preset
Memory No. 1. If no stations are memorized, it returns to the original station you were
listening to before the Auto Memory Preset procedure began.
15