Alpine CDA-9830R - Page 33

CDA-9830R
Descri
p
tion of IC Terminal
D78F4216AGC : IC001
No. Symbol I/O Terminal Description
1 IF MUTE O IF MUTE control terminal. (H:IF MUTE ON)
2
3
4 RDS-CONT O
RDS data input prevention control terminal of adjoining station.
(H:RDS OFF)
5 IF MUTE(NC)
6
I
8
9 VDD - Power supply terminal.
10 X2
11 X1
12 VSS - GND terminal.
13 XT2(NC) - No connect terminal.
14 XT1(GND) - GND terminal.
15 RESET I System reset input terminal.
16 BATT-DET I BATT compulsion stand-by signal input terminal from VDD IC.
17 STANDBY I Stand-by signal input terminal from Main µ-COM.
18 NC - No connect terminal.
19 IS BUS Fin I IS BUS frame signal input terminal.
20
I
22
23 AVDD - Analog power supply terminal of A/D converter.
24 AVREF0 I Standard voltage input terminal of A/D converter.
25 S-METER I Signal-Meter input terminal.
26 MULTIPATH I Multipath input terminal of RDS Decoder.
27 ADJCH-DET I Adjoining station detect input terminal.
28 SSTOP I FM station detect signal input terminal.
29 AMST/MP I SEEK STOP detect input terminal at AM. (H:Station ON)
30 AFC I FM station detect signal input terminal.
31
32
33 AVSS - GND terminal of A/D converter.
34
35
36 AVREF1 I Standard voltage input terminal of D/A converter.
37 IS BUS RX I IS BUS receiving terminal.
38 IS BUS TX O IS BUS transmitting terminal.
39 IS BUS Fout O IS BUS frame signal output terminal.
40 MONITOR RXD I Command input terminal for RDS monitor (P/C). (Pull-up connect)
41 MONITOR TXD O Status output terminal for RDS monitor (P/C).
42
I
47
48 T-MUTE O MUTE signal output terminal to Main µ-COM.
49
50
NC - No connect terminal.
NC - No connect terminal.
NC - No connect terminal.
- No connect terminal.
NC
- Crystal OSC connect terminal for main system clock OSC. (12.288MHz)
NC - No connect terminal.
NC(GND) - GND terminal.
NC - No connect terminal.
TO CONTENTS
TO SCHEMATIC
- 39 -