Jeep Wrangler
HCE-RCAM-WRA 4/16
Factory Unit Disassembly Process (2007-2010 Only)
DISCONNECT THE BATTERY BEFORE
CONTINUING. FAILURE TO DO SO WILL
DISABLE MANY FEATURES.
1 Remove top by releasing 2 rear clips on the back of
the top panel and then pull panel forward.
3 Release 2 clips on the top of the bottom panel. This
will expose two 7mm screws. Remove using a 7mm
socket with ratchet & extension.
5 Extract (4) 7 mm screws and remove the factory
radio.
2 Release 2 clips on the top of the bottom panel. This
will expose two 7mm screws. Remove those.
4 Use panel removal tool to remove dash panel by
releasing 6 clips (3 per side)
Warning: Before you begin wiring, remove the ground wire from the negative
terminal of the battery. Failing to do so can lead to electric shock, injury or damage
to equipment.
To Next Page
Loading...