10-EN
Priority News
This function allows you to preset to give priority to the News
programme. You will never miss the News programme as the unit
automatically gives priority to the News programme whenever it begins
broadcasting, and interrupts the programme you are currently listening.
This feature is functional when your unit is set to a mode other than the
LW and MW modes.
1
Press FUNC./SETUP to activate the Function mode
while the unit is in Radio (FM receiving) mode.
The <F> indicator lights up.
2
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) to select NEWS,
and press
/
ENTER.
3
Turn the Double Action encoder (iDA-X200 only)
or Rotary encoder (iDA-X300 only) to select ON,
and press
/
ENTER.
4
Press to return to normal mode.
The <F> indicator goes out.
The “NEWS” indicator appears in the display.
• Operate the unit while the <F> indicator lights up. If no operation is
performed for 10 seconds, the <F> indicator goes out.
• In the NEWS function, unlike in the TA function, the volume does not
increase automatically.
Displaying Radio Text
Text messages from a radio station can be displayed.
Press VIEW while receiving FM in the radio mode to
select the Radio Text display.
The display will change every time the button is pressed.
If there is PS (Programme Service Name)
If there is no PS (Programme Service Name)
• If there is no receivable text information or the unit cannot receive
text information properly, “NO TEXT” will be displayed.
iDA-X200
iDA-X300
An iPod
®
can be connected to this unit by using the proprietary
ALPINE FULL SPEED
TM
Connection Cable (KCE-422i) (sold
separately) (or the iPod Dock interface cable (supplied, iDA-X200
only)). When this unit is connected by using the cable, the controls on
the iPod are not functional.
• Only 5th generation iPod, first generation iPod nano and second
generation iPod nano can be connected via a USB device (iDA-X200
only).
• Set AUX+ to OFF when an iPod is connected (refer to “Setting the
AUX+ Mode” on
page 23).
• If the Bluetooth Box and an iPod are connected at the same time, be
sure to disconnect the iPod from the Bluetooth Box while turning
ACC to OFF.
About iPods usable with this unit
• The unit can be used with the fourth generation and above
iPod, iPod photo, iPod mini, the first generation iPod nano or
the second generation iPod nano only. However, future
generation iPod compatibility cannot be guaranteed.
• Touch wheel or scroll wheel type iPods without the dock
connector cannot be connected to the unit.
• The unit can be used with the following iPod.
<USB connected> (iDA-X200 only)
Fifth generation iPod
First generation iPod nano
Second generation iPod nano
<Directly connected>
Fourth generation iPod
Fifth generation iPod
iPod photo
iPod mini
First generation iPod nano
Second generation ipod nano
• If the unit is used with iPod software versions of iTunes earlier than
7.1.0.59, correct function and performance are not guaranteed.
Band
PS (Programme
Service Name)
Band
PS (Programme
Service Name)
Radio Text
Band
Frequency
Radio Text
Band
Frequency
iPod
®
(Optional)
FUNC./SETUP
SOURCE
/
/ENTER
Double Action encoder
VIEW
FUNC./SETUP
SOURCE
/
/ENTER
Rotary encoder
VIEW
To Next Page
Loading...
