If
an
ACC
power supply
is
not available
Connection Diagram
of
SPST
Switch (sold separately)
iLX-F259
ACC
(Red)
,----------------,
______
7
'-'~'--------4~~-----
•
~F-U~S=E~(~SA')
SPST
SW
(Optional) : (Optional)
0
BATTERY
------------------------------1:::::J.-.J
(Yellow)
FUSE
(20A)
(Optional)
• If your
vehicle
has
no
ACC power
supply,
add
an
SPST
(single-pole,
single-throw) switch
(sold
separately)
and fuse
(sold
separately).
•
The
diagram
and the fuse
amperage
shown
above
are
in
the
case
when
the
unit
is
used
individually.
• If
the
switched power (ignition)
lead
of
the
unit
is
connected
directly
to
the
positive (+)post
of
the
vehicle's
battery,
the
unit
draws
some
current
(several
hundred milliamperes)
even
when
its
switch
is
placed
in
the
OFF
position, and
the
battery may
be
discharged.
To
prevent external
noise
from entering the audio
system.
• Locate
the
unit
and route
the
leads at least 10 cm away from
the
car harness.
• Keep
the
battery power leads
as
far away from
other
leads
as
possible.
• Connect
the
ground
lead securely
to
a bare metal spot (remove any paint,
dirt
or
grease
if
necessary}
of
the
car chassis.
•
If
you add an optional noise suppressor, connect
it
as
far away from
the
unit
as
possible. Your Alpine dealer carries various noise
suppressors, contact
them
for
further
information.
• Your Alpine dealer knows best
about
noise prevention measures
so
consult your dealer
for
further
information.
11-EN
I
To Next Page
Loading...
