EasyManua.ls Logo

Alpine iLX-F309 - Camera Interrupt Setting (Power off Mode); Factory System Setup

Alpine iLX-F309
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
44-EN
Rear Camera screen example
When Hitch Guide is set to Off
You cannot adjust the position of the yellow guide line ” in
the center independently.
It is controlled by a system to be the center of the two yellow guide
lines ” and “ ” on the left and right, or the central green
line “ ” and red guide line “ ”.
When Hitch Guide is set to On
You can adjust the Hitch Guide to mark the position of the junction
between your vehicle and your trailer.
4 Tou ch [], [], [] or [] to adjust the position of the
guide.
Touching [Clear] clears adjustments and returns to the setting
before guide line alteration.
5 After the adjustment is completed, touch [Set].
Adjusting Guides Simultaneously
<Rear Camera>
1 Tou ch [Link].
The 3 vertical guides of the currently-selected guide link
together, allowing them to be adjusted simultaneously.
When Hitch Guide is set to Off
Note on the yellow guide line “ ” in the center
The yellow guide line “ ” in the center is controlled by a system that
locates it in the center of the two yellow guide lines, “ ” and “
on the left and right, or the green line “ on the top and red guide
line “ ” below. Therefore you cannot move it manually.
When Hitch Guide is set to On
Turning Guide Display On/Off
Turning the selected guide off.
1 Tou ch [On/Off].
The currently selected guide will turn off.
2 To turn the guide on, touch [On/Off] again.
Guides that are turned off are still adjustable.
Returning Guides to Default
1 Tou ch [Default].
A message window will appear.
2 Tou ch [OK].
Adjusted values will return to default settings.
You can set whether to display the rear camera image when the gear
lever is moved to the reverse (R) position while the unit is turned off.
You can select this item only when Camera Select is “Rear.
Setting item:
Camera Interrupt (Power Mode)
Setting contents:
On (Initial setting) / Off
Factory System Setup
[Factory System Setup] is selected on the System Setup Menu screen in
step 1. See “System Setup” (page 43).
Camera Interrupt Setting (Power OFF Mode)
On: The rear camera image is displayed
Off: The rear camera image is not displayed

Table of Contents

Other manuals for Alpine iLX-F309

Related product manuals