Alpine iLX-F309 - External Accessories Setup; Setting the Default Vehicle Screen; Setting the External Accessory Control; Setting the External Audio Processor

45-EN
You can set whether the following source icon in the Menu screen is
available.
Setting item:
USB/iPod (Initial setting: Both) / SiriusXM (Initial setting: Aftermarket)
Setting contents:
Both / Factory / Aftermarket
* USB/iPod only.
• The iDataLink source icons not displayed on the Menu screen when no
iDataLink module is connected even though “Both” or “Factory” is set.
• You cannot set the source that is currently being played.
Press and hold the (Favorite) button for at least 2 seconds or touch
the Menu screen (page 18) to display the Info mode screen, and then set
the following.
Setting item:
Default Vehicle Screen
Setting contents:
Climate / Vehicle Info. / Gauges / Parking Assist / Last mode (Initial setting)
• Depending on the car, some setting contents or this setting item may not
be displayed.
You can change the setting of the connected iDataLink module.
Setting item:
Maestro Module
• Depending on the iDataLink module, the setting contents may differ.
External Accessories Setup
[External Accessories] is selected on the System Setup Menu screen in
step 1. See “System Setup” (page 43).
When using an external audio processor, set to “On” ( ).
Setting item:
External Audio Processor
Setting contents:
Off (Initial setting) / On
• When this setting is “On,” the Volume level is fixed at 10. Also, Balance/
Fader/Subwoofer Level/Subwoofer Phase/Bass/Treble/MX HD/EQ
Presets/Dual HD EQ/X-Over/Time Correction/Defeat/Phone Speaker/
Default Sound Settings are set to “Off” or “Flat” and cannot be
adjusted.
• Use the External Audio Processor to adjust volume.
When you have connected the optional External Accessory Control
module, set this setting to “On” to turn the headlights ON/OFF or adjust
the air suspension from this unit.
Setting item:
External Accessory Ctrl
Setting contents:
Off (Initial setting) / On
• When set to “On,” the [Ext Acc Ctrl] icon is displayed on the Menu
screen.
• For details on the External Accessory screen and its operation, see
“External Accessory Control Operation” (page 80).
Setting the Source Category
Both*: Both the sources listed above from this unit and
iDataLink module are available.
Factory: Only the source listed above from iDataLink module is
available.
Aftermarket: Only the source listed above from this unit is available.
Setting the Default Vehicle Screen
Setting the Maestro Module
Setting the External Audio Processor
Setting the External Accessory Control