Alpine iLX-F409 - Adjusting the Bass;Treble; Setting the Subwoofer; Graphic Equalizer Curve Settings (Graphic EQ)

20-EN
Equalizer Settings
[EQ Presets] is selected on the Sound Setup Menu screen.
10 typical equalizer settings are preset at the factory for a variety of
musical source material.
Setting item:
EQ Presets
Setting contents:
FLAT (Initial setting) / POP / ROCK / CLASSICAL / JAZZ / ELECTRONIC / HIP
HOP / EASY LISTENING / COUNTRY / NEWS
• Only one type can be set to On.
• When Equalizer Presets is set, the linked Graphic EQ settings are also
changed. We recommend storing Graphic EQ settings in a Preset in
advance.
• The Equalizer Presets setting can be configured when Defeat is Off.
Fader/Balance/Bass/Treble/Subwoofer Settings
[Fader/Balance/Bass/Treble/SubW.] is selected on the Sound Setup
Menu screen.
Setting item:
Fader/Balance/Bass/Treble/SubW.
Cancel
Sound setup finishes.
Fader/Balance Image area
Touch the desired point within the image area, or touch [F]
(Front), [R] (Rear), [L] (Left) or [R] (Right).
Fader:
15 (F) to 15 (R)
Balance:
15 (L) to 15 (R)
• To reset to the initial setting (F/R: 0, L/R: 0), touch [ ].
Touch [ ] or [ ] for each item to be adjusted.
Setting item:
Bass, Treble
Setting contents:
-10 to 10 (Initial setting: 0)
Adjusting the Subwoofer Level
Setting item:
Sub W.Level
Setting contents:
0 (Initial setting) to 15
• This setting is only available when “Subwoofer” is set to [On] (page 22).
Setting the Subwoofer Phase
The subwoofer output phase is toggled Subwoofer Normal (0°) or
Subwoofer Reverse (180°).
Setting item:
Sub W.Phase
Setting contents:
0° (Initial setting), 180°
• This setting is only available when “Subwoofer” is set to [On] (page 22).
Graphic Equalizer Curve Settings (Graphic EQ)
[Graphic EQ] is selected on the Sound Setup Menu screen.
You can modify the Equalizer settings to create a response curve more
appealing to your personal taste.
Setting item:
Graphic EQ
Setting contents:
-7 to 7
• This setting is only available when “Defeat” is set to [On] (page 22).
1 To uc h [Graphic EQ] on the Sound Setup menu screen.
2 Touch the band to be adjusted.
3 To uc h [] or [] to adjust the level of the band.
• You can also adjust the level of the band by moving the slider.
4 To adjust another band, repeat step 2 to 3, and adjust all
bands.
Setting the Fader/Balance
Adjusting the Bass/Treble
Setting the Subwoofer