The Firmware must be updated with one USB device.
There is one firmware update file for the current Alpine radio generation:
iLX-F905D, iLX-F115D, iLX-705D & i905D.
First, please download the “iLX-F905D_USB-Stick.zip” and follow the instructions.
The iLX-F905D / iLX-F115D / iLX-705D / i905D can be updated via
USB 1 connection (see connection diagram below). Before starting the update,
please check following notes. The download file is compressed in zip format. The
contents of the download files need to be extracted to a freshly formatted USB
device (FAT32). The update takes 5 to 10 minutes.
Notes
• Do NOT use the compressed file for update, otherwise the unit cannot recognize the files.
• Do NOT change folder name and file names, otherwise the unit cannot recognize the files.
• Do NOT store the folder inside another folder.
• Do NOT store any other folders/files on the USB device.
• Do NOT remove the USB device while updating.
• Do NOT update while driving.
• Do NOT press any buttons while updating.
• Do NOT turn off the vehicle’s ignition or head unit’s power switch while updating.
Modern vehicles will shut down the ignition (ACC) after some time if the engine is not
running. If you are not sure if this applies to your car, leave the engine idling while the
update is in progress.
Update file contents / storage place
Connection
ALPS ALPINE EUROPE GmbH, Alpine Brand
Firmware Update Instructions
User Guide
iLX-F905D / iLX-F115D
iLX-705D / i905D
iLX-F905D / iLX-F115D / iLX-705D / i905D Serie
Software Update Procedure
To Next Page
Need help?
General
