98-EN
Connections
• Set the system switch to “NORM” when only a changer is connected (when the Ai-NET compatible equalizer is not used).
When the IMPRINT audio processor is connected, set to EQ/DIV position.
* The system switches are located on the bottom of the unit.
(Red)
CD Changer
(Sold Separately)
Amplifier
Amplifier
Amplifier
Rear Left
Rear Right
Front Left
Front Right
Subwoofers
(White)
(Yellow)
(Red)
(White)
(Yellow)
Antenna
ISO Antenna Plug
Battery
Ignition key
Front left
Rear left
Rear right
Front right
Speakers
(Blue/White)
(Blue)
(Pink/Black)
(Yellow/Blue)
(Yellow)
(Black)
(Red)
(Green)
(Green/Black)
(White/Black)
(Grey)
(Violet/Black)
(Violet)
AUDIO INTERRUPT IN
REMOTE TURN-ON
PARKING BRAKE
ACC
GND
POWER ANT
BATTERY
(Grey/Black)
(White)
To remote input lead
To remote output lead
To plus side of the back lamp
signal lead of the car
Not used
To guide control input terminal
To steering remote control
interface box
Microphone (Included)
GPS Antenna
To Video Output terminal
To Audio Output terminals
(R,L)
To Video Input terminal
To Audio Input terminals
(R,L)
To Guide Input terminal
To Camera with RCA Output terminal
To power antenna
To the vehicle speed pause line
To the parking brake signal lead
To amplifier or equalizer
Not used
(Green/White)
SPEED SENSOR
GUIDE
(Black)
CAMERA IN
(Yellow)
GUIDE CONT
(White/Green)
CAMERA SW
(Black)
REVERSE
(Orange/White)
REMOTE IN
(White/Brown)
REMOTE OUT
(White/Brown)
To USB memory/
Portable audio player
To iPod/iPhone
or
(Black)
To Next Page
Loading...
