Alpine INE-F409E - System Setup; Camera Setup

41
[System] is selected on the Setup main screen in step 3. See “Setup
Operation” (page 24).
System Setup Menu screen
<Setting items>
*1 When you select “Camera Selector” in “Camera Select”, the setting item
is different. For details, see “Setting Multi Camera to On/Off”
(page 43).
*2 When Camera Select is set to “Off,” you cannot select this item.
*3 You can select this item only when Camera Select is “Front” or “Rear.”
*4 You can select this item only when Camera Select is “Rear.”
*5 You can set this item only when Camera Select is “Rear”, or when
“Camera Selector” is selected and “Rear Camera” is “On”.
*6 Set this setting after closing the Alpine TuneIt App.
1 Select the desired item.
2 To switch the setting, touch [], [], [], [], or mark the
checkboxes “Off” ( ) or “On” ( ).
• If “ ” appears, there is a further hierarchy. Touch the desired
item.
3 Tou ch [] to return to the main source screen.
• To return to the previous List screen, touch []. For details, see
“About Basic Operation for List Screen” (page 16).
Camera Setup
[Camera] is selected on the System Setup Menu screen in step 1. See
“System Setup” (page 41).
You can set up items related to the Camera.
Setting item:
Camera Select
Setting contents:
Off (Initial setting) / Front / Rear / Other / Camera Selector
* When selecting Camera Selector, you can set the Front Camera/Rear
Camera/Side Camera to On/Off. For details, see “Setting Multi Camera
to On/Off ” (page 43).
When the camera is connected, the video input signal type can be
chosen.
Further setting item:
Camera Signal
Setting contents:
NTSC (Initial setting) / PAL
The video pattern can be changed when connected to Multi View
Camera.
When Camera Select is set to “Off ” or “Other,” you cannot select this
item.
Setting item:
Guide Adjustment
1 Tou ch [Guide Adjustment].
The camera guide adjustment screen is displayed.
Multi View compatible Side Camera
2 Tou ch [Front] or [Rear].
The view will change to the selected view.
System Setup
Camera*
1
Camera Select
Camera Signal*
2
Guide Adjustment*
3
Interrupt (Power OFF)*
4
Shutdown Delay*
5
CAN-I/F
Default Vehicle Screen
Climate screen interrupt time
Parking sensor interrupt
Unit
External AP
Application
Alpine TuneIt App*
6
The following steps 1 to 3 are common to each “Setting
item” of System Setup. See each section for details.
Setting the Camera Input
Front: Front camera
Rear: Rear camera
Other: Side camera, Room camera, etc.
Camera
Selector*:
Front Camera/Rear Camera/Side Camera connected to
the optional Multi Camera Interface module.
Setting the Camera Signal Input
Switching Video Patterns for Multi View
Camera