Alpine INE-S900R - Installation

EN
EN-11
ALPINE INE-S900R 68-13530Z27-A
Owner’s manual Installation
Installation
When making connections to the vehicle’s •
electrical system, be aware of the factory installed
components (e.g. on-board computer). Do not
tap into these leads to provide power for this
unit. When connecting the INE-S900R to the fuse
box, make sure the fuse for the intended circuit
of the INE-S900R has the appropriate amperage.
Failure to do so may result in damage to the unit
and/or the vehicle. When in doubt, consult your
Alpine dealer.
The main unit must be mounted within 40 degrees •
of the horizontal plane, back to front.
0 - 40°
1 Check accessory parts.
GPS Antenna
(5 m)
Waterproof pad
(for GPS
antenna)
Antenna
mounting plate
×5
Cable clamp
(for GPS
antenna)
Microphone
(3.5 m)
Power cable
AUX/PRE OUT
connector cable
External Interface
connector cable
USB cable
Face plate Mounting sleeve Rubber cap
×2
×6
Hex bolt Bracket key Flush head screw
×8
Screw
2 Mount the GPS Antenna on the roof.
Clean dust and oil at the mounting
location and mount the GPS Antenna.
GPS Antenna
Mounting the GPS Antenna inside e
the vehicle.
1 Clean the mounting location.
2 Put on the GPS Antenna mounting plate.
3 Mount the GPS Antenna.
GPS Antenna
Antenna mounting plate
3 Routing the GPS Antenna cable.
1 Route the cable using the provided cable
clamps to take up the cable’s slack.
2 Use the waterproof pad when running the
cable under one of the vehicle’s rubber
gaskets.
3 Attach the cable at several points using
the remaining cable clamps.
Cable clamp
Waterproof pad