95-EN
Installation Setup
[Installation] is selected on the General setup menu in step 4. See
“General Setup Operation” (page 91).
The system status information are viewable.
Setting item: Installation check
1
Touch [View].
The Installation check screen is displayed.
2
Touch [ ] to return to the previous screen.
You can set the system to be unusable without entering a password.
When you set this setting to On and set a password, the password input
is required when the system is connected to a battery and turned on for
the first time.
Setting item: Security code
Setting contents: On / Off (Initial setting)
Setting the password
1
Touch [On].
2
After the confirmation message appears, touch
[Yes].
The password setting screen is displayed.
3
Enter a password, then touch [OK].
• Enter the 6-digit number.
• Input numbers are displayed as “*”.
4
Enter the same password again, then touch [OK].
The password is set and the system returns to the previous
screen.
• If you forget a registered password, you can not use this unit. In this
case, service will be required.
Clearing the password
1
Touch [Off].
The password setting screen is displayed.
2
Enter the password you have set, then touch [OK].
The password is cleared and the system returns to the
previous screen.
• Input numbers are displayed as “*”.
Installation check
Setting Security code
Downloaded from Caradio-Manual.com Manuals
To Next Page
Loading...
