Alpine INE-W611D - RDS Operation and Traffic Info; Traffic Announcements and AF Settings; Regional Stations and Sound Settings; Regional Tuning and Audio Adjustments

21 -EN
RDS Operation
Trafc Announcement
Touch .
The “TA” indicator is displayed and the unit switches to standby
mode to receive trafc announcements.
When a trafc announcement is received, the “TP” indicator lights
up and a corresponding popup is displayed. Press [Close] to close.
Press [TA Off] to turn the TA feature off.
• The “TP” indicator lights up during standby mode off in a condition
other than radio source to indicate that the unit is receiving the
trafc announcement.
• If the trafc announcement broadcast signal falls below a certain
level, the unit remains in the receiving mode for 1 minute.
Receiving Trafc Information Manually
1
Touch to turn on the Trafc Information
mode.
The “TA” indicator lights up.
2
Touch or .
Seeks the broadcast station which is broadcasting the trafc
information.
• You can seek the trafc information in DX Seek mode.
Turning AF (Alternative Frequencies)
On or Off
The RDS (Radio Data System) is a radio information system using
the 57 kHz subcarrier of regular FM broadcasts. The RDS allows
you to receive a variety of information such as traffic information,
station names, and to automatically re-tune to a stronger transmitter
that is broadcasting the same programme.
1
Touch .
2
Check the [AF] box to turn the feature on.
When AF is turned on, the “AF” indicator will be lit up.
• RDS mode is not displayed for the MW or LW band.
• When the AF is turned on, the unit automatically tunes to a strong
signal broadcast in the AF list.
• Turn the AF off when automatic re-tuning is not required.
Regional Stations
This feature allows users to lock-down the device to their
current region or allow the radio to tune into other region specic
programming.
1
Touch .
2
Check the [Regional] box to turn the feature on.
When Regional feature is turned off, the unit automatically
keeps receiving the local RDS station.
Sound Settings
Touch
→
[Sound Settings]
For details, refer to the “Sound” on the page 65.