Alpine IVA-D100 - Installing the Power Amplifier; Installing the DC;DC Converter

70-EN
01GB07IVA100.fm
ALPINE IVA-D100 68-05946Z49-A (EN)
Installing the Power Amplifier
When mounting with Velcro fasteners
When mounting the Power Amplifier with the Velcro fasteners, be sure
to choose a flat location.
Do not hang the unit from the bottom of the dashboard or rear deck with
the Velcro fasteners.
1 Remove the Protective paper and attach two pieces
of Velcro fastener to the bottom of the Power
Amplifier.
2 Check the position, and then fix the Power Amplifier
to the floor carpet.
When mounting with Screws
When mounting the Power Amplifier with the screws, be sure to choose
a flat location.
When making holes, be careful not to scratch any pipes or wires.
1 Install the Power Amplifier on the floor with the
supplied hexagonal screw (M4 × 15).
Installing the DC/DC Converter
Install the DC/DC Converter on the floor with the
supplied flange-head tapping screws (M4 × 14).
This Power Amplifier is designed for use only with the IVA-D100. If
products other than IVA-D100 are connected to the supplied
Power Amplifier, its specified performance is not guaranteed.
Power
Amplifier
Protective paper
Velcro Fasteners
(Included)
Protective paper
Power Amplifier
hexagonal screw (M4 × 15)
(Included)
DC/DC Converter
Flange-head tapping
screws (M4 × 14)
(Included)
01GB00IVAD100.book Page 70 Tuesday, February 14, 2006 4:10 PM