29-EN
Switching the Visual Source Only
(Simultaneous Function)
You can watch the video portion of another source while listening to the
current source.
1
Touch [VISUAL] on the audio source screen.
The VISUAL selection screen appears.
2
Touch desired visual source.
The visual source is switched to the selected one.
1
Press VISUAL.
2
Touch [NORMAL].
The simultaneous function is cancelled.
• To apply the setting, set to VISUAL in “Setting the VISUAL Button”
(
page 39).
• If a DVD player is connected, you can receive the DVD picture.
DVD changer (DHA-S680P) is connected:
Press and hold V.OUT on the remote control supplied with the DVD
player or DVD changer for more than 2 seconds. The picture of the
DVD will be output.
The DVA-5210 or DHA-S690 is connected:
Press V.OUT on the remote control (included with the DVA-5210 or
DHA-S690) to output DVD picture.
• The simultaneous function cannot be used when the Audio source is
in the navigation mode.
When NAV. is set in “Setting the VISUAL Button” (page 39), only the
navigation screen can be recalled.
• When the “Setting the AUX Mode” (page 38) is set to OFF, the
auxiliary source is not displayed.
Blackout Mode On and Off
When Blackout mode is turned on, the monitor display will turn off to
reduce power consumption.
This additional power enhances the sound quality.
1
Touch [VISUAL] on the main source screen.
The VISUAL selection screen is displayed.
2
Touch [OFF].
The backlit-display portion goes out.
3
Touch [OFF] again to cancel the display backlight.
• To apply the setting, set to VISUAL in “Setting the VISUAL Button”
(
page 39).
• If any button on the unit is pressed during Blackout mode, the
function will be displayed for 5 seconds to show the operation before
returning to Blackout mode.
Setting rear Camera Interruption
When the rear camera is connected, rear pictures are output on the
screen.
1
Select ON in “Setting the Rear Camera Input”
(
page 38).
2
Touch [VISUAL] on the main source screen.
The VISUAL selection screen is displayed.
3
Touch [CAMERA].
Rear picture is output even if you do not engage the shift
lever in reverse (R).
4
To cancel the setting, press VISUAL on the unit,
and touch [NORMAL].
• By shifting to reverse (R),the rear pictures are output. This function is
effective when the reverse wire is properly connected.
Cancelling the Simultaneous Function
To Next Page
Loading...
