47-EN
Adjusting the Frequency
Setting contents:BAND 1: 20 Hz~80 Hz
BAND 2: 50 Hz~200 Hz
BAND 3: 125 Hz~3.2 kHz
BAND 4: 315 Hz~8 kHz
BAND 5: 800 Hz~20 kHz
Touch [ ] or [ ] of FREQ., then adjust the frequency of
the selected band.
Adjusting the Level
Setting contents: -6 dB to +6 dB
Touch [ ] or [ ] of LEVEL, then adjust the level of the
selected band.
Setting the Bandwidth
Setting contents: 1/1.5/3
Touch [ ] or [ ] of Q.
Select the bandwidth.
• When the parametric EQ is adjusted, the adjustment for graphic EQ
becomes ineffective.
• The frequencies of adjacent bands cannot be adjusted within 4 steps.
• While adjusting the Parametric EQ, you should consider the
frequency response of the connected speakers.
Equalizer Presets (Factory’s EQ)
10 typical equalizer settings are preset at the factory for a variety of
musical source material.
Setting contents: F-EQ
1
Touch [ ] of F-EQ.
The F-EQ list screen appears.
2
Set to ON by touching [ ] or [ ] of the desired
equalizer characteristic.
FLAT / POPS / ROCK / NEWS / JAZZ & BLUES /
ELECTRICAL DANCE / HIP HOP & RAP / EASY LISTENING /
COUNTRY / CLASSICAL / USER 1~6
• By selecting USER 1 to 6, you can recall the stored preset number in
“Graphic Equalizer Adjustments” or “Parametric Equalizer
Adjustment”.
Setting the Response Slope for the High
Range Speaker (TW Setup)
Depending on the response characteristics of the speaker, care should be
taken when setting the response slope of the high range speaker to
FLAT in 2.2ch (3WAY) mode (see “X-OVER Adjustment” on
page 45),
as speaker damage may result.
Setting item: TW SETUP
Setting contents: MAKER / USER
• Only if the 3WAY (2.2CH) switch is toggled between FRONT/REAR/
SUBW. (4.2CH) and 3WAY (2.2CH) on the IMPRINT audio
processor (PXA-H100), you can select the TW SETUP mode.
Storing Settings in the Memory
Adjustment or setting contents can be stored.
Contents that can be stored vary depends on the IMPRINT audio
processor used.
1
Touch [MEMORY] on the A.PROCESSOR list
display.
2
Within 5 seconds, touch any one of the preset
buttons [P.SET 1] through [P.SET 6] on the
A.PROCESSOR list.
The setting contents are stored.
• The stored contents will not be deleted even when the battery power
cord is detached.
Touch Preset buttons [P.SET 1] through [P.SET 6] on
the A.PROCESSOR list to select the preset memory you
want to recall from Preset buttons.
• It takes a few moment to recall the preset memory.
MAKER: As protection from possible speaker damage, FLAT
cannot be set for the response slope of the high range
speaker in 2.2ch (3WAY) mode.
USER: The FLAT setting is possible in 2.2ch (3WAY) mode.
Recalling the Preset Memory
To Next Page
Loading...
