91-EN
Fuse Holder (10A)
ISO Power Supply Connector
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (–) Speaker Output Lead (White/Black)
Right Front (–) Speaker Output Lead (Grey/Black)
Right Front (+) Speaker Output Lead (Grey)
Right Rear (–) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
ISO Connector (Speaker Output)
Power Supply Connector
iPod (V)/AUX Input Connector
Input the iPhone/video compatible iPod audio/video signal
or AUX video/audio signal.
• Set “AUX2 IN” to “iPod Video” in “Setting the AUX Mode”
(page 47) when an iPhone or a video compatible iPod is connected.
• Set “AUX2 IN” to “AUX” in “Setting the AUX Mode” (page 47)
when normal AUX video/audio is input.
Digital Output Terminal (Optical)
Use when combining fiber optic digital input compatible
products. Be sure to use the Optical Digital Cable
(KWE-610A) (sold separately) only.
AV Connector
System Switch
When connecting an equalizer or divider using Ai-NET
feature, place the two switches in the EQ/DIV position.
When no device is connected, leave the switch in the
NORM position.
Change both switches to the left to set to the NORM
position.
Change both switches to the right to set to the EQ/DIV
position.
(If the front panel is viewed from the front.)
• Do not make the two switches to different settings.
• Be sure to turn the power off to the unit before changing the switch
position.
To Next Page
Loading...
Need help?
General
