Rear
Entertainment
Function
The rear entertainment function independently routes different sources
to the front and the rear inside a car. For example. while listening to the
radio
or
other audio source in the front, DVD can be enjoyed in the rear
with the optional rear monitor and headphones.
1 Touch
[SOURCE]
on the main source screen.
The SOURCE selection screen is displayed.
2 Touch [RSE].
Rear Select display appears.
• Touching [MAIN] on the REAR selection screen will change to the
main source screen.
3 Touch the desired source such as visual (auxiliary
input, built-in DVD) to select.
• Touch [OFF] to cancel the rear entertainmentfunction.
• When the "Setting the AUX
Mode"
(page 38) is set to
OFF,
the
auxiliary source is not displayed.
SWitching
Display
Modes
After carrying out the steps I to 3
of
"To display the DVD mode screen"
explained on page 29. perform the operation described below.
While your vehicle is parked, touch
[WIDE]
on the visual
source screen.
Each touch changes the display modes as follows:
MODE 1
~
MODE 2
~
MODE 3
~
MODE 1
(WIDE) (CINEMA) (NORMAL) (WIDE)
In
Mode 1 (Wide), the monitor displays a normal picture wider
to
fit
in
a wide-screen monitor by evenly stretching out the picture
horizontally.
In
Mode 2 (Cinema), the monitor displays a normal picture
by
stretching out the picture horizontally and vertically. This mode is
good for displaying a cinema type picture at the 16:9 ratio.
In
Mode 3 (Normal), the monitor displays a normal picture at the
center of the screen with a vertical black band at each side.
28-EN
Switching
the
Visual
Source
Only
(Simultaneous
Function)
You
can watch the video portion
of
another source while listening to the
current source.
• After carrying out the steps I to
3
of
"To display the DVD mode
screen" explained on page 29. perform the operation described
below.
1 Touch
[VISUAL]
on the audio source screen.
The VISUAL selection screen appears.
2 Touch a desired visual source.
The visual source is switched
to
the selected one.
1 Touch the visual screen to display the main control.
2 Touch [ESC].
3 Touch
[VISUAL]
within 5 seconds.
The VISUAL selection screen appears.
4 Touch
[NORMAL].
The simultaneous function is canceled.
•
To
make the setting. set to "Setting the VISUAL Soft Button"
(page 39).
•
If
a DVD player is connected. you can receive the DVD picturel
sound.
DVD changer (DHA-S680) is connected:
Press
and
hold V.OUT on the remote control supplied with the DVD
player
or
DVD changer
for
more than 2 seconds. The picture
and
sound
of
the DVD will be output.
The DVA-52IO is connected:
Press V.OUT on the remote control (included with the DVA-52IO) to
output DVD picturelsound.
• The simultaneousfunction cannot be used when the Audio source is
in
the navigation mode.
When
NAV.
is set in "Setting the VISUAL Soft Button" (page 39).
only the navigation screen can be recalled.
Blackout
Mode
On
and
Off
When Blackout mode is turned on. the monitor display will turn
off
to
reduce power consumption.
This additional power enhances the sound quality.
1 Touch
[VISUAL]
on the main source screen.
The VISUAL selection screen is displayed.
2 Touch
[OFF].
The backlit-display portion goes out.
3 Touch
[OFF]
again to cancel the display backlight.
•
To
make the setting. set to VISUAL in "Setting the VISUAL Soft
Button" (page 39).
•
If
any button on the unit is pressed during Blackout mode. the
function
will be displayedfor 5 seconds to show the operation before
returning to Blackout mode.
Rear
Entertainment
Function
The rear entertainment function independently routes different sources
to the front and the rear inside a car. For example. while listening to the
radio
or
other audio source in the front, DVD can be enjoyed in the rear
with the optional rear monitor and headphones.
1 Touch
[SOURCE]
on the main source screen.
The SOURCE selection screen is displayed.
2 Touch [RSE].
Rear Select display appears.
• Touching [MAIN] on the REAR selection screen will change to the
main source screen.
3 Touch the desired source such as visual (auxiliary
input, built-in DVD) to select.
• Touch [OFF] to cancel the rear entertainmentfunction.
• When the "Setting the AUX
Mode"
(page 38) is set to
OFF,
the
auxiliary source is not displayed.
SWitching
Display
Modes
After carrying out the steps I to 3
of
"To display the DVD mode screen"
explained on page 29. perform the operation described below.
While your vehicle is parked, touch
[WIDE]
on the visual
source screen.
Each touch changes the display modes as follows:
MODE 1
~
MODE 2
~
MODE 3
~
MODE 1
(WIDE) (CINEMA) (NORMAL) (WIDE)
In
Mode 1 (Wide), the monitor displays a normal picture wider
to
fit
in
a wide-screen monitor by evenly stretching out the picture
horizontally.
In
Mode 2 (Cinema), the monitor displays a normal picture
by
stretching out the picture horizontally and vertically. This mode is
good for displaying a cinema type picture at the 16:9 ratio.
In
Mode 3 (Normal), the monitor displays a normal picture at the
center of the screen with a vertical black band at each side.
28-EN
Switching
the
Visual
Source
Only
(Simultaneous
Function)
You
can watch the video portion
of
another source while listening to the
current source.
• After carrying out the steps I to
3
of
"To display the DVD mode
screen" explained on page 29. perform the operation described
below.
1 Touch
[VISUAL]
on the audio source screen.
The VISUAL selection screen appears.
2 Touch a desired visual source.
The visual source is switched
to
the selected one.
1 Touch the visual screen to display the main control.
2 Touch [ESC].
3 Touch
[VISUAL]
within 5 seconds.
The VISUAL selection screen appears.
4 Touch
[NORMAL].
The simultaneous function is canceled.
•
To
make the setting. set to "Setting the VISUAL Soft Button"
(page 39).
•
If
a DVD player is connected. you can receive the DVD picturel
sound.
DVD changer (DHA-S680) is connected:
Press
and
hold V.OUT on the remote control supplied with the DVD
player
or
DVD changer
for
more than 2 seconds. The picture
and
sound
of
the DVD will be output.
The DVA-52IO is connected:
Press V.OUT on the remote control (included with the DVA-52IO) to
output DVD picturelsound.
• The simultaneousfunction cannot be used when the Audio source is
in
the navigation mode.
When
NAV.
is set in "Setting the VISUAL Soft Button" (page 39).
only the navigation screen can be recalled.
Blackout
Mode
On
and
Off
When Blackout mode is turned on. the monitor display will turn
off
to
reduce power consumption.
This additional power enhances the sound quality.
1 Touch
[VISUAL]
on the main source screen.
The VISUAL selection screen is displayed.
2 Touch
[OFF].
The backlit-display portion goes out.
3 Touch
[OFF]
again to cancel the display backlight.
•
To
make the setting. set to VISUAL in "Setting the VISUAL Soft
Button" (page 39).
•
If
any button on the unit is pressed during Blackout mode. the
function
will be displayedfor 5 seconds to show the operation before
returning to Blackout mode.
To Next Page
Loading...
