General
Setup
Operation
To
display the General mode screen:
To
watch a video source, your vehicle must be parked with the
ignition key
in
the ACC or
ON
position.
To
do this, follow the
procedure below.
Bring your vehicle to a
complete
stop
at
a safe
location.
Engage
the parking brake.
2
Keep
pushing
the foot brake
and
release the
parking
brake
once
then
engage
it again.
3 When the
parking
brake
is
engaged
for the
second
time, release the foot brake.
•
For
automatic transmission vehicles, place the transmission lever
in the Park position.
Now,
the locking system for the General mode operation has
been released. Engaging the parking brake can reactivate the
General mode, as long
as
the car's ignition has not been turned
off.
It
is
not necessary to repeat the above procedure
(1
through
3) of
"To
display the General mode screen."
Each time the ignition
is
turned
OFF,
perform the procedure of
"To
display the General mode screen."
The following steps 1 to4
are
common operations to each
"Setting item"
of
GENERAL Setup. Refer to each section for
details.
1 Touch
[SETUP]
on the main source screen.
The SETUP selection screen is
displayed.
2 Touch
[GENERAL
SETUP].
The GENERAL SETUP screen
appears.
3 Touch [
....
],
[~]
or
[»
] etc.,
of
the desired item
to
change Its setting.
setting
items:
CLOCK I CLOCK ADJUST I DAYLIGHT
SAVING
TIME
I
DEMONSTRATION I
BEEP
I AUTO SCROLL I
LED
DIMMER
LEVEL
4 Touch
[~]
to
return
to
the previous screen.
Touch
and
hold
[~l
for at least 2
seconds
to return to the
main source screen that was
displayed
before
the
setup
operation
was
started.
• Immediately after changing the settings
o/General
Mode (While the
system
is writing data automatically) do not turn the ignition key
(engine key) to
OFF.
Otherwise, the settings may not be changed.
36-EN
The clock indication on the monitor display is turned on or off
respectively.
Setting item: CLOCK
Setting contents: OFF
ION
Setting Item: CLOCK ADJUST
Furthersetting
Items:
HOUR 1MINUTE1TIME ADJUST
setting
contents: 1·1210-591RESET
HOUR: Adjust the
hour.
MINUTE: Adjust the minute.
RESET:
If
the clock shows less than 30 minutes past, the
minute will be
":
0"; more than
30,
the hour
advances.
• The clock-adjusting mode is canceled when the power is turned off,
when
[~]
or
[ESC] is touched.
Setting Item: DAYLIGHTSAVING TIME
Setting contents: OFF
ION
OFF: Return to the ordinary time.
ON: Place the Summer Time mode ON. The time advances by
one hour.
This unit is equipped with a demonstration function capable
of
showing
basic operations
of
respective sources on the monitor display.
Setting Item: DEMONSTRATION
Setting contents: OFF
ION
OFF:
Turns
off the demonstration mode.
ON: Turns on the demonstration mode to show the basic
operations.
• The demonstration operation is automatically repeated until the
function
is turned off.
Setting item: BEEP
Settmgcon~nm:OFFION
OFF: Deactivate the Sound Guide mode.
The
sound guide
beep will not be produced when a button on the unit is
pressed.
ON: Activate the Sound Guide mode.
General
Setup
Operation
To
display the General mode screen:
To
watch a video source, your vehicle must be parked with the
ignition key
in
the ACC or
ON
position.
To
do this, follow the
procedure below.
Bring your vehicle to a
complete
stop
at
a safe
location.
Engage
the parking brake.
2
Keep
pushing
the foot brake
and
release the
parking
brake
once
then
engage
it again.
3 When the
parking
brake
is
engaged
for the
second
time, release the foot brake.
•
For
automatic transmission vehicles, place the transmission lever
in the Park position.
Now,
the locking system for the General mode operation has
been released. Engaging the parking brake can reactivate the
General mode, as long
as
the car's ignition has not been turned
off.
It
is
not necessary to repeat the above procedure
(1
through
3) of
"To
display the General mode screen."
Each time the ignition
is
turned
OFF,
perform the procedure of
"To
display the General mode screen."
The following steps 1 to4
are
common operations to each
"Setting item"
of
GENERAL Setup. Refer to each section for
details.
1 Touch
[SETUP]
on the main source screen.
The SETUP selection screen is
displayed.
2 Touch
[GENERAL
SETUP].
The GENERAL SETUP screen
appears.
3 Touch [
....
],
[~]
or
[»
] etc.,
of
the desired item
to
change Its setting.
setting
items:
CLOCK I CLOCK ADJUST I DAYLIGHT
SAVING
TIME
I
DEMONSTRATION I
BEEP
I AUTO SCROLL I
LED
DIMMER
LEVEL
4 Touch
[~]
to
return
to
the previous screen.
Touch
and
hold
[~l
for at least 2
seconds
to return to the
main source screen that was
displayed
before
the
setup
operation
was
started.
• Immediately after changing the settings
o/General
Mode (While the
system
is writing data automatically) do not turn the ignition key
(engine key) to
OFF.
Otherwise, the settings may not be changed.
36-EN
The clock indication on the monitor display is turned on or off
respectively.
Setting item: CLOCK
Setting contents: OFF
ION
Setting Item: CLOCK ADJUST
Furthersetting
Items:
HOUR 1MINUTE1TIME ADJUST
setting
contents: 1·1210-591RESET
HOUR: Adjust the
hour.
MINUTE: Adjust the minute.
RESET:
If
the clock shows less than 30 minutes past, the
minute will be
":
0"; more than
30,
the hour
advances.
• The clock-adjusting mode is canceled when the power is turned off,
when
[~]
or
[ESC] is touched.
Setting Item: DAYLIGHTSAVING TIME
Setting contents: OFF
ION
OFF: Return to the ordinary time.
ON: Place the Summer Time mode ON. The time advances by
one hour.
This unit is equipped with a demonstration function capable
of
showing
basic operations
of
respective sources on the monitor display.
Setting Item: DEMONSTRATION
Setting contents: OFF
ION
OFF:
Turns
off the demonstration mode.
ON: Turns on the demonstration mode to show the basic
operations.
• The demonstration operation is automatically repeated until the
function
is turned off.
Setting item: BEEP
Settmgcon~nm:OFFION
OFF: Deactivate the Sound Guide mode.
The
sound guide
beep will not be produced when a button on the unit is
pressed.
ON: Activate the Sound Guide mode.
To Next Page
Loading...
