You
can select a mode suitable for
the
subject image.
L.L.C.
Setting
Operation
Setting item: VISUAL EO
Setting contents:
OFF
(FLAT) I NIGHT
M.
I
SOFT
I SHARPI
CONTRASTlp·1Ip·2
•
To
return to the initial setting after selecting
anyone
of
the setting
contents (NIGHT
M,
to CONTRAST)
and
adjusting a desired
brightness, picture tint, etc., set thisfunction to
OFF.
•
If
your desired brightness, picture tint, etc., are adjusted after
selecting
anyone
of
the setting contents (NIGHT
M.
to CONTRAST),
"CUSTOM" is displayed.
To
dIsplay the L.L.C. mode
screen:
To
watch a video source, your vehicle must be parked with
the
ignition key
in
the ACC
or
ON
position.
To
do
this, follow the
procedure below.
Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake
once
then
engage
it again.
3 When the parking
brake
is
engaged
for the
second
time, release the foot brake.
•
For
automatic transmission vehicles, place the transmission lever
in the Park position.
Now,
the locking system for the L.L.C. mode operation has been
released. Engaging the parking brake can reactivate the L.L.C.
mode,
as
long as the car's ignition has not been turned
off.
It
is
not necessary
to
repeat the above procedure
(1
through 3) of
"To
display the L.L.C. mode screen."
Each time the ignition
is
turned
OFF,
perform the procedure of
"To
display the L.L.C. mode screen."
OFF
(FLAT):
NIGHTM.:
SOFT:
SHARP:
CONTRAST:
P-l:
P-2:
Initial Selling
Suitable for movies
in
which dark scenes
frequently appear.
Suitable for CGs and animated films.
Suitable for old movies where images
are
not
clearly shown.
Suitable for recent movies.
Recalls
the
VISUAL
EO
mode being stored
on
preset
NO.P-1
from
"Storing VISUAL
EO"
(page 41).
Recalls
the
VISUAL
EO
mode being saved
on
preset
NO.P-2
from "Storing VISUAL
EO"
(page 41).
The following steps 1 to 4 are
common
operations to
each
''Setting
item"
of
L.L.C. Setup. Refer to
each
section
for
details.
1 Touch
[SETUP]
on the main source screen.
The SETUP selection screen is displayed.
2 Touch
[L.L.C.
SETUP].
The L.L.C. SETUP screen appears.
3 Touch [
....
] or
[~]
etc.,
of
the desired item to change
its setting.
setting Items:
L.L.C.* H VISUAL EO* H BRIGHT H COLOR* H
T1NT*
H
CONTRAST H SHARP*
HUSER
MEMORY*
* The setting is available in the visual source mode (except navigation
screen).
4 Touch
[~]
to return to the previous screen.
Touch
and
hold
[~J
for at least 2
seconds
to return to
the
main source screen that was displayed before
the
setup
operation was started.
• Only one setting item can be displayed on each page, you can select
the desired brightness. picture tint, etc through the screen displayed.
SettIng item: BRIGHT
Setting content:
·15 - +15
You
can
adjust the brightness between MIN
(-15)
and
MAX
(+15), When it reaches the minimum or maximum point, the
display shows "MIN" or "MAX" respectively.
• When any Visual EQ Preset is selected, the brightness is
automatically adjustedaccording to the car's interior lighting as
long as AUTO is set in "Setting the Brightness
of
the Backlighting"
(page 35).
Setting item: COLOR
Setting content:
·15 - +15
You
can
adjust the color between MIN
(-15)
and MAX (+15),
When it reaches the minimum or maximum point, the display
shows "MIN" or "MAX" respectively,
• Color adjustment can be made only in the navigation, DVD, Video
CD,
AUX modes.
• Color adjustment cannot be made
ifa Navigation system with the
RGBfeature is connected.
Darker Brightness
f-
Darkness Balance
~
Brighter
This function allows picture darkness (brighter black/deeper black) of a
dark scene to
be
adjusted.
setting item: L.L.C.
Setting contents:
OFF
I 1
12
13
I 4 I 5
You
can
adjust the level of picture adjustment effectiveness
between 1 and 5.
• Tint adjustment can be made only in the fUlvigation, DVD, Video
CD,
AUXmodes,
• Tint adjustment cannot be made
if
a Navigation system with the RGB
feature is connected.
When setting
PAL.
you can not adjust the
TINT.
Setting item:
nNT
Setting content: G15 - R15
Adjust
the color from
G15
to
R15. "G MAX" or
"R
MAX" is
displayed
at the maximum of
each
color.
5
4
32
40-EN
You
can select a mode suitable for
the
subject image.
L.L.C.
Setting
Operation
Setting item: VISUAL EO
Setting contents:
OFF
(FLAT) I NIGHT
M.
I
SOFT
I SHARPI
CONTRASTlp·1Ip·2
•
To
return to the initial setting after selecting
anyone
of
the setting
contents (NIGHT
M,
to CONTRAST)
and
adjusting a desired
brightness, picture tint, etc., set thisfunction to
OFF.
•
If
your desired brightness, picture tint, etc., are adjusted after
selecting
anyone
of
the setting contents (NIGHT
M.
to CONTRAST),
"CUSTOM" is displayed.
To
dIsplay the L.L.C. mode
screen:
To
watch a video source, your vehicle must be parked with
the
ignition key
in
the ACC
or
ON
position.
To
do
this, follow the
procedure below.
Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake
once
then
engage
it again.
3 When the parking
brake
is
engaged
for the
second
time, release the foot brake.
•
For
automatic transmission vehicles, place the transmission lever
in the Park position.
Now,
the locking system for the L.L.C. mode operation has been
released. Engaging the parking brake can reactivate the L.L.C.
mode,
as
long as the car's ignition has not been turned
off.
It
is
not necessary
to
repeat the above procedure
(1
through 3) of
"To
display the L.L.C. mode screen."
Each time the ignition
is
turned
OFF,
perform the procedure of
"To
display the L.L.C. mode screen."
OFF
(FLAT):
NIGHTM.:
SOFT:
SHARP:
CONTRAST:
P-l:
P-2:
Initial Selling
Suitable for movies
in
which dark scenes
frequently appear.
Suitable for CGs and animated films.
Suitable for old movies where images
are
not
clearly shown.
Suitable for recent movies.
Recalls
the
VISUAL
EO
mode being stored
on
preset
NO.P-1
from
"Storing VISUAL
EO"
(page 41).
Recalls
the
VISUAL
EO
mode being saved
on
preset
NO.P-2
from "Storing VISUAL
EO"
(page 41).
The following steps 1 to 4 are
common
operations to
each
''Setting
item"
of
L.L.C. Setup. Refer to
each
section
for
details.
1 Touch
[SETUP]
on the main source screen.
The SETUP selection screen is displayed.
2 Touch
[L.L.C.
SETUP].
The L.L.C. SETUP screen appears.
3 Touch [
....
] or
[~]
etc.,
of
the desired item to change
its setting.
setting Items:
L.L.C.* H VISUAL EO* H BRIGHT H COLOR* H
T1NT*
H
CONTRAST H SHARP*
HUSER
MEMORY*
* The setting is available in the visual source mode (except navigation
screen).
4 Touch
[~]
to return to the previous screen.
Touch
and
hold
[~J
for at least 2
seconds
to return to
the
main source screen that was displayed before
the
setup
operation was started.
• Only one setting item can be displayed on each page, you can select
the desired brightness. picture tint, etc through the screen displayed.
SettIng item: BRIGHT
Setting content:
·15 - +15
You
can
adjust the brightness between MIN
(-15)
and
MAX
(+15), When it reaches the minimum or maximum point, the
display shows "MIN" or "MAX" respectively.
• When any Visual EQ Preset is selected, the brightness is
automatically adjustedaccording to the car's interior lighting as
long as AUTO is set in "Setting the Brightness
of
the Backlighting"
(page 35).
Setting item: COLOR
Setting content:
·15 - +15
You
can
adjust the color between MIN
(-15)
and MAX (+15),
When it reaches the minimum or maximum point, the display
shows "MIN" or "MAX" respectively,
• Color adjustment can be made only in the navigation, DVD, Video
CD,
AUX modes.
• Color adjustment cannot be made
ifa Navigation system with the
RGBfeature is connected.
Darker Brightness
f-
Darkness Balance
~
Brighter
This function allows picture darkness (brighter black/deeper black) of a
dark scene to
be
adjusted.
setting item: L.L.C.
Setting contents:
OFF
I 1
12
13
I 4 I 5
You
can
adjust the level of picture adjustment effectiveness
between 1 and 5.
• Tint adjustment can be made only in the fUlvigation, DVD, Video
CD,
AUXmodes,
• Tint adjustment cannot be made
if
a Navigation system with the RGB
feature is connected.
When setting
PAL.
you can not adjust the
TINT.
Setting item:
nNT
Setting content: G15 - R15
Adjust
the color from
G15
to
R15. "G MAX" or
"R
MAX" is
displayed
at the maximum of
each
color.
5
4
32
40-EN
To Next Page
Loading...
