New
Discs
To prevent the
CD
from
jamming,
"DISC
ERROR"
is
displayed
if
discs with irregular surfaces are inserted
or
if
discs are inserted
incorrectly.
When
a new disc is ejected immediately after initial
loading, use
your
finger to feel around the inside
of
the center hole
and outside edge
of
the disc.
If
you feel any small bumps
or
irregularities, this could inhibit proper loading
of
the disc. To
remove the bumps, rub the inside edge
of
the hole and outside edge
of
the disc with a ballpoint pen
or
other such instrument, then insert
the disc again.
~
PRECAUTIONS
Product
Cleaning
Use a soft dry cloth for periodic cleaning
of
the product. For more
severe stains, please dampen the cloth with water only. Anything
else has the chance'of dissolving the paint
or
damaging the plastic.
Temperature
Be sure the temperature inside the vehicle is between +4S
o
C
(+1
13°F) and
O°C
(+32°F) before turning your unit on.
Moisture
Condensation
You may notice the disc playback sound wavering due to
condensation.
If
this happens, remove the disc from the player and
wait about an hour for the moisture to evaporate.
~ce""HOI'
Bumps
CenterH~1e
'--_
/ New Disc
...
~~
-:~'
,..,..."
~._.~r.':::.-
- - " '
.............
Outside
(Bumps)
Damaged
Disc
Do not attempt to play cracked, warped,
or
damaged discs. Playing
a bad disc could severely damage the playback mechanism.
Maintenance
If
you have problems,
do
not attempt to repair the unit yourself.
Return it to
your
Alpine dealer
or
the nearest Alpine Service
Station for servicing.
Never
Attempt
the
Following
Do
not grip
or
pull
out
the disc while it is being pulled back into the
player by the automatic reloading mechanism.
Do
not attempt to insert a disc into the unit when the unit power is
off.
Inserting
Discs
Your player accepts only
one
disc at a time for playback.
Do
not
attempt to load more than
one
disc.
Make sure the label side is facing up when you insert the disc,
"DISC
ERROR" will be displayed on your player
if
you insert a
disc incorrectly.
If
"DISC
ERROR" continues to be displayed even
though the disc has been inserted correctly, push the
RESET
switch
with a pointed object such as a ballpoint pen.
Playing a disc while driving on a very bumpy road may result in
skips, but this will not scratch the disc
or
damage
the
player.
Irregular
Shaped
Discs
Be sure to use round shaped discs only for this unit and never use
any special shaped discs.
Use
of
special shaped discs may cause damage to the mechanism.
6-EN
Installation
location
Make sure the IVA-WSOS will not be installed in a location
subjected to:
• Direct sun and heat
• High humidity and water
• Excessive dust
• Excessive vibrations
Correct
Handling
Do
not
drop
the disc while handling. Hold the disc
so
you will not
leave fingerprints on the surface.
Do
not affix tape, paper,
or
gummed
labels to the disc.
Do
not write on the disc.
CORRECT
?f
~
-~
INCORRECT
CORRECT
X
0
~
~
<---
Disc
Cleaning
Fingerprints, dust,
or
soil on the surface
of
the disc could cause the
DVD
player to skip. For routine cleaning, wipe the playing surface
with a clean, soft cloth from the center
of
the disc to the outer edge.
If
the surface is heavily soiled, dampen a clean, soft cloth in a
solution
of
mild neutral detergent before cleaning the disc.
New
Discs
To prevent the
CD
from
jamming,
"DISC
ERROR"
is
displayed
if
discs with irregular surfaces are inserted
or
if
discs are inserted
incorrectly.
When
a new disc is ejected immediately after initial
loading, use
your
finger to feel around the inside
of
the center hole
and outside edge
of
the disc.
If
you feel any small bumps
or
irregularities, this could inhibit proper loading
of
the disc. To
remove the bumps, rub the inside edge
of
the hole and outside edge
of
the disc with a ballpoint pen
or
other such instrument, then insert
the disc again.
~
PRECAUTIONS
Product
Cleaning
Use a soft dry cloth for periodic cleaning
of
the product. For more
severe stains, please dampen the cloth with water only. Anything
else has the chance'of dissolving the paint
or
damaging the plastic.
Temperature
Be sure the temperature inside the vehicle is between +4S
o
C
(+1
13°F) and
O°C
(+32°F) before turning your unit on.
Moisture
Condensation
You may notice the disc playback sound wavering due to
condensation.
If
this happens, remove the disc from the player and
wait about an hour for the moisture to evaporate.
~ce""HOI'
Bumps
CenterH~1e
'--_
/ New Disc
...
~~
-:~'
,..,..."
~._.~r.':::.-
- - " '
.............
Outside
(Bumps)
Damaged
Disc
Do not attempt to play cracked, warped,
or
damaged discs. Playing
a bad disc could severely damage the playback mechanism.
Maintenance
If
you have problems,
do
not attempt to repair the unit yourself.
Return it to
your
Alpine dealer
or
the nearest Alpine Service
Station for servicing.
Never
Attempt
the
Following
Do
not grip
or
pull
out
the disc while it is being pulled back into the
player by the automatic reloading mechanism.
Do
not attempt to insert a disc into the unit when the unit power is
off.
Inserting
Discs
Your player accepts only
one
disc at a time for playback.
Do
not
attempt to load more than
one
disc.
Make sure the label side is facing up when you insert the disc,
"DISC
ERROR" will be displayed on your player
if
you insert a
disc incorrectly.
If
"DISC
ERROR" continues to be displayed even
though the disc has been inserted correctly, push the
RESET
switch
with a pointed object such as a ballpoint pen.
Playing a disc while driving on a very bumpy road may result in
skips, but this will not scratch the disc
or
damage
the
player.
Irregular
Shaped
Discs
Be sure to use round shaped discs only for this unit and never use
any special shaped discs.
Use
of
special shaped discs may cause damage to the mechanism.
6-EN
Installation
location
Make sure the IVA-WSOS will not be installed in a location
subjected to:
• Direct sun and heat
• High humidity and water
• Excessive dust
• Excessive vibrations
Correct
Handling
Do
not
drop
the disc while handling. Hold the disc
so
you will not
leave fingerprints on the surface.
Do
not affix tape, paper,
or
gummed
labels to the disc.
Do
not write on the disc.
CORRECT
?f
~
-~
INCORRECT
CORRECT
X
0
~
~
<---
Disc
Cleaning
Fingerprints, dust,
or
soil on the surface
of
the disc could cause the
DVD
player to skip. For routine cleaning, wipe the playing surface
with a clean, soft cloth from the center
of
the disc to the outer edge.
If
the surface is heavily soiled, dampen a clean, soft cloth in a
solution
of
mild neutral detergent before cleaning the disc.
To Next Page
Loading...
