42-EN
Outputs the picture of the source selected on the IVA-W520R connected
to the rear monitor.
Setting item: AUX OUT
Setting contents: OFF / ON
Setting item: BLUETOOTH IN
Setting contents: OFF / HFP / HFP+AUDIO / NAV.
• For details on BLUETOOTH operation, refer to the Owner’s Manual
of the BLUETOOTH INTERFACE.
• If a mobile phone compatible with the Voice Dial function is
connected, the Voice Dial function can be used.
Setting item: VISUAL KEY
Setting contents: VISUAL / NAV.
The unit’s (OPTION) button function can be changed.
Setting item: OPTION KEY
Setting contents: AUDIO SETUP / MAP / REAR SEL.
You can input the audio of an external device, (such as a Portable audio
player) to the BLUETOOTH interface connector of this unit. A special
Conversion cable (KCE-237B) is necessary to adapt the BLUETOOTH
interface connector as an AUX IN.
A portable music device and a BLUETOOTH INTERFACE cannot be
connected to the BLUETOOTH interface connector at the same time.
Setting item: AUX+ IN
Setting contents: OFF / ON
• When OFF is selected, the settings related to AUX+ cannot be
changed from this unit.
After setting to ON in “Setting the AUX+ Mode”, this setting can be
carried out.
Setting item: AUX+ LEVEL
Setting contents: LOW / HIGH
Setting the Picture Output
OFF: The “RSE” item is not displayed on the SOURCE
selection screen.
ON: The “RSE” item is displayed on the SOURCE selection
screen.
Touch [RSE] to change to the REAR selection screen,
and then touch the desired source. The selected source
picture is output on the rear monitor.
Setting the BLUETOOTH Connection
(BLUETOOTH IN)
OFF: Select to ignore any external interrupts.
HFP: Select when the optional BLUETOOTH
INTERFACE (KCE-250BT) is connected and
the BLUETOOTH Hands-Free Phone function
is used. For details, refer to the Owner’s
Manual of KCE-250BT.
HFP+AUDIO: Select when the optional BLUETOOTH
INTERFACE (KCE-400BT) is connected and
the BLUETOOTH Hands-Free Phone/
BLUETOOTH Audio function is used. For
details, refer to the Owner’s Manual of
KCE-400BT.
NAV.:
Select when the optional portable navigation
is connected.
The TEL screen of the portable navigation is
displayed.
Setting the VISUAL Soft Button
VISUAL: Recalls the VISUAL selection screen by touching
[VISUAL].
NAV.: Switches directly to the navigation screen by touching
[VISUAL].
Setting the OPTION Button on the Unit
AUDIO SETUP: Press (OPTION) to recall the AUDIO SETUP
screen.
MAP: Press (OPTION) to recall the navigation
map screen.
REAR SEL.: Press (OPTION) to recall the Real selection
screen. (Only when ON is set in “Setting the
Picture Output” (page 42))
Setting the AUX+ Mode
OFF: AUX+ source is not displayed.
ON: AUX+ source is displayed.
Adjusting the AUX+ Audio Level
LOW: Decreases the external input audio level.
HIGH: Increases the external input audio level.
To Next Page
Loading...
