15.01.2013
4
7. Confirm that "Visible Mode" is set
to ON.
In case there is no paired device, you will not be able to
enter this menu. In that case skip this section.
8. Enter the "Clear Device" menu.
9. Click on a paired device. 10. Confirm by pushing "Yes"
Repeat step 9&10 with other paired devices until the list
is empty
3. Push the "Page DN" button 4. Confirm that "BLUETOOTH IN" is
set to "HFP+AUDIO"
6. Select "Source Setup", then
"Bluetooth Setup"
5. Go back to "Setup Sel." by pushing
the "back" key
To Next Page
Loading...