38-EN
01GB05IVE-W535BT.fm
ALPINE IVE-W535BT 68-21057Z54-A (EN)
Date/Time Setting
[Date/Time] is selected on the General setup menu in step 3. Refer to
“General Setup Operation” (page 37).
You can switch the calendar display pattern to be shown when the time
is displayed.
Setting item: Calendar Type
Setting contents: M/D / D/M (Initial setting)
You can select the clock display type, 12-hour or 24-hour, depending on
your preference.
Setting item: Clock Mode
Setting contents: 12h / 24h (Initial setting)
When On is selected, the clock is adjusted automatically based on the
time data sent from the RDS broadcast.
Setting item: RDS Clock DISP
Setting contents: Off (Initial setting) / On
Setting item: Clock Adjust
Additional items: Year / Month / Day / Hour / Minute
Setting contents: 2012~ / JAN-DEC / 1-31 / 01-12 or 00-23 / 00-59
(Initial setting: 2012 / JAN / 1 / 00 / 00)
• Touch and hold [ ] or [ ] to run through a change sequence
automatically.
• Clock adjustment can be made when “RDS Time Display” (page 38)
is set to “Off.”
Remote Sensor Setting
[Remote Sensor] is selected on the General setup menu in step 3. Refer
to “General Setup Operation” (page 37).
For remote control operation, the remote sensor of the external device
(monitor, etc.) can be switched, as you prefer.
Setting item: Remote Sensor
Setting contents: Front (Initial setting) / Rear
• If the RSE (page 52) is “Off,” the setting is not displayed.
Security Code Setting
[Security Code] is selected on the General setup menu in step 3. Refer
to “General Setup Operation” (page 37).
You can set the system to be unusable without entering a password.
When you turn this setting to “On” and set a password, password input
is required when the system is connected to a battery and turned on for
the first time.
Setting item: Security Code
Setting contents: Off (Initial setting) / On
Setting the password
1
Touch [ ] or [ ] of “Security Code” to set to “On.”
2
After the confirmation message appears, touch
[OK].
The password setting screen is displayed.
3
Enter a password, then touch [OK].
• Enter the 6-digit number.
• Input numbers are displayed as “*.”
4
Enter the same password again, then touch [OK].
The password is set and the system returns to the previous
screen.
• If you forget a registered password, you can not use this unit. In this
case, service will be required.
Clearing the password
1
Touch [] or [] of “Security Code” to set to “Off.”
The password setting screen is displayed.
2
Enter the password you have set, then touch [OK].
The password is cleared and the system returns to the
previous screen.
• Input numbers are displayed as “*.”
Setting of Calendar Display Pattern
Switching
M/D: shows the month/day
D/M: shows the day/month
Setting the Clock Display
RDS Time Display
Off: To adjust it manually.
On: Adjust the clock automatically based on the time data. In
this case, the clock cannot be adjusted manually.
Setting the Time
Ye a r : Adjust the year.
Month: Adjust the month.
Day: Adjust the day.
Hour: Adjust the hour.
Minute: Adjust the minute.
Front: The remote sensor of this unit is effective.
Rear: The remote sensor of the external monitor
connected to AUX OUTPUT of this unit
becomes effective. The remote control
operates the source connected to the AUX
OUTPUT terminals.
Setting Security code
01GB00IVE-W535BT.book Page 38 Sunday, August 5, 2012 6:45 PM
To Next Page
Loading...
