83-EN
01GB06IVE-W554ABT.fm
ALPINE IVE-W554ABT/IVE-W554EBT 68-25285Z79-A (EN)
Connection Diagram of SPST Switch (sold separately)
(If the ACC power supply is not available)
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when IVE-W554ABT/IVE-W554EBT is used individually.
• If the switched power (ignition) lead of the IVE-W554ABT/IVE-W554EBT is connected directly to the positive (+) post of the vehicle’s battery, the
IVE-W554ABT/IVE-W554EBT draws some current (several hundred milliamperes) even when its switch is placed in the OFF position, and the
battery may be discharged.
IVE-W554ABT
IVE-W554EBT
(Red)
(Yellow)
SPST SW (Optional)
FUSE (5A)
(Optional)
FUSE (20A)
(Optional)
Battery
ACC
BATTERY
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
01GB00IVE-W554ABT.book Page 83 Friday, January 24, 2014 5:43 PM
To Next Page
Loading...
