29-EN
Time Setting
[Time] is selected on the General setup menu in step 3. Refer to
“General Setup Operation” (page 28).
The clock indication on the monitor display is turned on or off
respectively.
Setting item: Clock Display
Setting contents: Off / Type A / Type B
You can select the clock display type, 12-hour or 24-hour, depending on
your preference.
Setting item: Clock Mode
Setting contents: 12h / 24h (Initial setting)
• When the Clock Display setting is set to “Off,” setting is not
available.
Setting item: Hour
Setting contents: AM12 - AM11 - PM12 - PM11 (12h) or
00 - 23 (24h)
• Touch and hold [-] or [+] to run through a change sequence
automatically.
• When the Clock Display setting is set to “Off,” setting is not
available.
Setting item: Minute
Setting contents: 00 - 59
• Touch and hold [-] or [+] to run through a change sequence
automatically.
• When the Clock Display setting is set to “Off,” setting is not
available.
Security Code Setting
[Security Code] is selected on the General setup menu in step 3. Refer
to “General Setup Operation” (page 28).
You can set the system to be unusable without entering a password.
When you turn this setting to “On” and set a password, password input
is required when the system is connected to a battery and turned on for
the first time.
Setting item: Security Code
Setting contents: Off (Initial setting) / On
Setting the password
1
Touch [ ] or [ ] of “Security Code” to set to “On.”
2
After the confirmation message appears, touch
[OK].
The password setting screen is displayed.
3
Enter a password, then touch [OK].
• Enter the 6-digit number.
• Input numbers are displayed as “*.”
4
Enter the same password again, then touch [OK].
The password is set and the system returns to the previous
screen.
• If you forget a registered password, you can not use this unit. In this
case, service will be required.
Clearing the password
1
Touch [] or [] of “Security Code” to set to “Off.”
The password setting screen is displayed.
2
Enter the password you have set, then touch [OK].
The password is cleared and the system returns to the
previous screen.
• Input numbers are displayed as “*.”
Clock Display Setting
Off: Not displayed
Typ e A : The clock indication is displayed in the upper right
corner of the screen when the Top banner fades out.
Typ e B : The clock indication is always displayed in the
bottom right corner of the screen.
Setting the Clock Mode
Setting the Time (Hour)
Setting the Time (Minute)
Setting Security code
To Next Page
Loading...
