Alpine MRP-F240 - Amplifier Installation and Connection Procedures; Amplifier Mounting and Wiring Basics

Specifications
T.H.D. (DC14.4V, 20Hz~20kHz) ....................................................................... 4ohm-Load/4ch, 35W Output : 0.2%
4ohm-Load/2ch (BTL), 95W Output : 1.0%
Power Output (Normal Input, DC14.4V, 20Hz~20kHz) ..................................... 0.2% T.H.D., 4ohm-Load/4ch : 35W
1.0% T.H.D., 4ohm-Load/2ch (BTL) : 90W
S/N Ratio (Ref. Output 35W/4ohm, Input Shorted) ............................................................................................ 94dB
Input Sensitivity (35W Output) .................................................................... GAIN-VR Center : RCA Input : 1.1V±5dB
SP Input : 2.2V±5dB
GAIN-VR CW : RCA Input : 0.2V±5dB
SP Input : 0.4V±5dB
GAIN-VR CCW : RCA Input : 4.5V±5dB
SP Input : 8.9V±5dB
Frequency Response Ratio (Ref. 1kHz, 0±1dB) ..................................................................................... 20Hz~40kHz
Current Drain ..................................................................................................................................... No Signal : 1.5A
4ohm-Load/4ch, T.H.D. 10% : 30A
Residual Noise (Input Shorted, 4ohm-Load/4ch, VR Center) ........................................................................... 3.0mV
Channel Separation (Input Shorted, 1kHz, 35W Output) .................................................................................... 55dB
Remote on Voltage (1W Output) .......................................................................................................... 6.5+1.0, -1.5V
Remote Current Drain ....................................................................................................................................... 3.0mA
Back-up Current Drain ...................................................................................................................................... 1.2mA
Input Impedance
............................................................................................................... RCA Input : 13.8±2.0kohm
SP Input : 13.8±2.0kohm
Power Source ........................................................................................................................... DC14.4V (9.0~16.0V)
Dimensions (W x H x D)
........................................................................................................... 265.6 x 60 x 241.4mm
Weight ............................................................................................................................................................... 2.54kg
NOTE : Due to Continuing product improvement, specifications and designs are subject to change without notice.
All manuals and user guides at all-guides.com