Alpine MRV-F400 - Switches and Terminals Identification; Precautions and Safety; General Safety Warnings

Refer to Fig. 1 on page 3.
®
®
@
®
©
©
@
®
®
@
Q@OESe@ @80898
POWER-On Indicator
INPUT MODE Selector Switch (Channels 1/2)
Crossover Mode Selector Switch (Channels 1/2)
Crossover Frequency Adjustment Knob (Channels 1/2)
Input GAIN Adjustment Control (Channels 1/2)
INPUT MODE Selector Switch (Channels 3/4)
Crossover Mode Selector Switch (Channels 3/4)
Crossover Frequency Adjustment Knob (Channels 3/4)
Input GAIN Adjustment Control (Channels 3/4)
RCA INPUT Jacks (Channels 1/2)
RCA INPUT Jacks (Channels 3/4)
RCA OUTPUT Jacks (Channels 1+3)
RCA OUTPUT Jacks (Channels 2+4)
Speaker Output Terminals (Channels 3/4)
Speaker Output Terminals (Channels 1/2)
Fuse Block
BATTery Lead Terminal
REMOTE Turn-On Lead Terminal
GrouND Lead Terminal
Improper wiring connections could cause damage to your vehicle's electrical
system and/or the MRV-F400 amplifier. Carefully follow the wiring instructions in
this manual.
Attaching the battery lead to the positive (+) terminal of the battery should be the
last connection after all other connections are made. ~
Due to the high power output of the MRV-F400, it is important that all connections
are clean and well secured, or damage could result.
Be sure that the MRV-F400 is mounted in a way that will allow for free air circula-
tion and heat dissipation.
When changing fuses, be sure to replace the old fuse with one of the same
amperage. Use of improper fuses can lead to serious damage to components.
10