Alpine MRV-F400 - Amplifier Installation Procedure; Mounting and Grounding Steps

Refer to Fig. 2 on page 4.
Due to the high power output of the MRV-F400, considerable heat is produced
when the amplifier is in operation. For this reason, the amplifier should be mounted in
a location which will allow for free circulation of air, such as inside the trunk. For
alternate installation locations, please contact your authorized Alpine dealer.
1. Using the amplifier as a template, mark the four screw locations.
2. Make sure there are no objects behind the surface that may become damaged
during drilling.
3. Drill the screw holes.
4. Position the MRV-F400 over the screw holes, and secure with four self-tapping
screws.
NOTE:
To securely connect the ground lead, use an already installed screw on the metal
part of the vehicle (marked (*)). Be sure this is a good ground by checking continuity
to the battery (—) terminal. As much as possible connect all equipment to the same
ground point. These procedures will help eliminate noise.
© Self-Tapping Screws (M4 x 14)
@ Ground Lead
@ Chassis
® Holes
16