• Re-Install the lens and lens retainer ensuring the “O” ring remains in the correct position in the
groove of the Power Beam™ Light.
• To maintain a good water tight seal, make sure the lens is flush with the front lip of the rubber
seal.
• To change your Power Beam™ color lens, remove the lens and replace it with a colored lens of
your choice.
• Make sure the lens is on the rubber seal then take the cover and place it correctly onto the slots of
the Power Beam™ turning tightly clockwise.
• Make sure the cover is tightly locked.
Limited Warranty Information:
For complete limited warranty information and details, please visit our
website at www.alpine4u.com
Troubleshooting your Power Beam™:
If light fails to illuminate, please check the following:
• Check that the light set is getting power by testing another applicant in the power outlet that the lights use
• Check to ensure that your light bulb has not burned out from usage
• If water gets into any of your Power Beam™ lights, lift it out of the water, remove the lens and empty the
water until dry
Caution & Warning:
• Always handle the light from the base. The light housing can and will become HOT!
• Operating the lights with missing or damaged covers can result in risk of fire or electrical shock
• Use ONLY recommended MR11 12 volt 10 watt halogen bulbs
• Do not exceed the voltage & wattage indicated on the transformer
• Keep away from flammable and/or children
• This light assembly has not been tested or deigned for use in swimming pools and hot tubs
To Previous Page
Loading...