3.7
Running a Simulation
To run a simulated navigation that demonstrates the planned route, perform the following steps:
1.
Press the navigation hardkey button to access the Navigation menu.
2.
In the Navigation menu, tap .
3.
Tap .
4.
Tap . The simulation starts from the starting point of the route and leads
you through the whole planned route using a realistic speed.
(optional) You have the following controls during the simulation (the control buttons disappear
after a few seconds but you can open them again if you tap the map):
• : Jump to the next route event (maneuver).
•
: Pause the simulation.
• : Jump to the previous route event (maneuver).
• : Tap to increase the speed of the simulation to 4, 8 or 16 times faster. Tap again
to return to normal speed.
To Next Page
Loading...
