hypercharger - Operation Instructions and Installation Guide
Hardware
Version 2-2
All rights reserved. The reproduction of this document, also partially, is allowed only with authorization by alpitronic Srl
1.3. Safety instructions for installation and maintenance
These warnings and instructions apply to all activities of installation, service and
maintenance on the hypercharger.
Attention
Any disregard from these instructions can lead to serious or fatal
personal injury, as well as serious damage to property.
Installation and maintenance of the hypercharger ultra-fast charging
system for electric vehicles must only be carried out by qualified
personnel.
Before putting the system into operation, check the correct state of the
installation and all connections.
Electrostatic discharge
The control cabinet contains components and circuit boards that are
sensitive to electrostatic discharge. During assembly and maintenance,
sufficient ESD measures should be taken to protect the electronic
components (for example, wearing a grounding wristband).
Warning of hazardous electrical voltage
Installation and maintenance of the hypercharger may be carried out only
while power is off/disconnected. Before performing any installation,
disassembly, repair or replacement of components, switch off the external
group switch and the main switch in the hypercharger cabinet and do a
voltage check to make sure that the electrical power is disconnected from
the system.
Inside the hypercharger cabinet, hazardous electrical voltages are present
(up to 1000 Vdc) even if all circuit breakers are switched off, do not allow
unqualified persons to go near it.
Only hypercharger certified technicians are permitted to install,
disassembly, repair or replace components on the hypercharger. The
hypercharger cabinet doors must be properly closed and locked after
installation, service or repair operations.
To Next Page
Loading...
Need help?
General
