© ALSTOM 2010. All rights reserved. Informat
this document is indicative only. No
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
change without notice. Reproduction, use or disclosure to
third parties, without express writt
Check presence and condition of retaining clips and spacer washers on the
axles of the control rod/crank assembly.
During all dismantling of the
replace the retaining clips
removed by new ones of the same type. For correct orientation of clips see
section entitled : “ERECTION”.
Check the electrical contact SF
If the values found are outside required tolerances replace the densimeter.
dure in section entitled : ”PRE-COMMISSIONING INSPECTIONS”.
are taken as a reference to judge how the apparatus evolves with time.
Check and adjust, with a torque wrench, the tightening torques of screws on
sub--assemblies not subjected to gas pressure. The tightening torques are
given in paragraph ”Tightening torques”.
With the electric cubicle out of service, check that the connectors and tips of
To Next Page
Loading...
