GEM80-400 1. Introduction
Issue 3 04/99 ALSPA GEM80-400 CONTROLLER TECHNICAL MANUAL Page 1-11
1.
1.7. 9032 Power Supply
The 9032 Power Supply Module is illustrated in Figure 1.4; this module is used
specifically with the Standard Controller. It should be noted that the 9032 Power
Supply Module is factory-set to 220V. This setting may need to be adjusted, depending
on the user's requirements. The specification for the power supply module is contained
in Chapter 6 of this manual.
Figure 1.4 - 9032 Power Supply Module
Note:
Different versions of this power supply may have slightly different front panels
with two fuses and five LEDs.
To Next Page
Loading...